TABLE OF CHANGES
    ITEMS
    SECTIONS
    PAGES
    Re-paginated table of contents, (revised).
    TOC
    TOC
    Chart 4 and Figures 6 and 7 revised to reserved status.
    Chart and Figure
    Contents
    i
    Rule number and bus inspection committee members’
    names, (revised).
    Preface
    ii
    Florida Statute and State Board Rule language, (revised).
    FL Statute and
    State Board Rule
    iii
    Statute references and contact information (revised)
    Specifications Notes
    v
    Technician’s and service manager’s initials, (revised).
    Instructions
    vii
    Inspection items A.5., A.15, D.2, D.10, and E.10, (revised).
    Inspection Form
    ix to xii
    Repair order form, (revised).
    Repair Order
    xiii and xiv
    Rule designation, Job description, waver letter, and
    journeyman level experience requirements, (revised and
    added).
    School Bus Inspection
    Certification Program
    xv
    School Bus Inspector test results notification, (revised).
    School Bus Inspection
    Certification Program
    xvi
    School Bus Inspection Trainer responsibilities, (revised).
    School Bus Inspection
    Certification Program
    xvii
    Supervisor II Certificate test, (revised).
    School Bus Inspection
    Certification Program
    xviii
    Inspection classification requirement table and notes,
    (revised).
    School Bus Inspection
    Certification Program
    xix
    Job description requirement and third party tester information,
    (added).
    School Bus Inspection
    Re-Certification
    Program
    xx
    Test grading procedures, (revised).
    School Bus Inspection
    Re-Certification
    Program
    xxi
    Form content reflecting changes found in School Bus
    Inspection Certification Program (pages xv through xix)
    (revised)
    Application for State of
    Florida School Bus
    Safety Inspector
    Certification.
    xxii and
    xxiii
    Form content reflecting changes found in School Bus
    Inspection Certification Program (pages xix through xxi)
    (revised)
    Application for State of
    Florida School Bus
    Safety Inspector Re-
    certification.
    xxiv and
    xxv
    Revised “locked” to “lockable” (revised)
    A. 1. a. 3)
    1
    Revised “locked” to “lockable” (revised)
    A. 1. b. 2)
    2
    Changed curlex bandage length to 6 “yards” (revised)
    Chart 1 Buses
    manufactured from
    1985 to present
    3
    Supp.
    03-1

    TABLE OF CHANGES (CONTINUED)
    ITEMS
    SECTIONS
    PAGES
    Revised “locked” to “lockable” (revised)
    5
    Throttle return spring language (revised)
    A. 4. c. 2)
    10
    ABS warning light, (added).
    A. 5. d.
    13
    PP1 knob missing, (added).
    A. 6. h.
    19
    Page number changes to accommodate added page
    (revised)
    A. 14 and 15
    45 to 51
    Passenger securement devices , (added).
    A. 15. h.
    52
    Webbing cutter, (added).
    A. 15. h.
    52
    Emergency exit language, (clarified).
    A. 16. a.
    53
    Tinted window language, (clarified).
    A. 17. b.
    57
    Lift door and lift equipment condition, (revised).
    A. 18. 1)
    59
    Non-aerosol chemical containers, (clarified).
    A. 21. f.
    66
    Added “Lights” to “Tail” through out section, (clarified).
    B. 1.
    67 to 71
    Corrected hazard lights wording, (revised).
    B. 1. c.
    69
    Corrected clearance and ID lights language, (revised).
    B. 2. a.
    72
    Level of damage to reflective striping, (clarified).
    B. 5. b.
    79
    Removed redundant bumper color inspection procedure from
    paint section, (revised).
    B. 5. d.
    80
    Wheel color requirement, (added).
    B. 5. d.
    80
    Reflective marking requirements, (clarified).
    B. 5. e.
    80
    Local bus number language, (clarified).
    B. 5. f.
    81
    Lubricant type language, (clarified).
    D. 1. a.
    114
    Locking-pin language, (clarified).
    D. 1. c.
    115
    Spring-pin language, (clarified).
    D. 1. f.
    117
    Front brake lining minimum thickness and measurement
    procedures, (revised).
    D. 2. f.
    123
    Front brake adjustment language, (clarified).
    D. 2. j.
    127
    Power steering reservoir cap and dipstick inspection
    procedure, (added).
    D. 5. d.
    135
    Missing fuel tank cap inspection procedure, (added).
    D. 6. a.
    136
    Spring pin language, (clarified).
    D. 9. h.
    146
    Rear brake measurement procedures (revised)
    D. 10. f.
    151
    Rear brake adjustment language, (clarified).
    D. 10. j.
    155
    Tailpipe inspection language, (clarified).
    D. 12. d.
    158
    Tire tread depth measurement language, (clarified).
    D. 13. a.
    159
    Wheel type and color requirements, (added).
    D. 13. f.
    163
    Corrected language in decelerometer procedure, (clarified).
    F. 1. b.
    167
    Supp.
    03-1

    Back to top